Need to speak to us? Here’s our most useful number and email addresses
General information: firstname.lastname@example.org
Heald’s Apex Static Bollard (UK Design number: 6145254) provides a shallow mount solution that is flexible and can easily adapt to a wide variety of locations due to its modular design.
The Apex Bollard was designed to enable simple and fast bollard installation in either a straight line or a curved array. The circular bollard is suitable for a variety of aesthetic finishes and covers, providing a seamless perimeter to both historic and contemporary architecture.
The Apex was tested in an array of 3 bollards, with the vehicle impacting perpendicular to a single bollard to offer maximum protection. The modular design means that the bollard line can be extended to provide protection along the full perimeter.
Apex Bollards are easy to install with an excavation depth
of only 150mm. The bollards are simply positioned with no pinning required and then secured in place with a concrete backfill. The surface can be finished with tarmac or pavers to create smooth integration with any landscape.
CREATING A CURVED ARRAY
Due to the unique design of the Apex bollard, tight curves and 90-degree angles are achievable without any modification to the bollard base. The bollard is mounted onto the base plate which is elongated to the rear of the product. Due to this shape, there are two maximum achievable radii for the curvature of the bollard line; this can be either towards or away from the protected area.
INTERIOR FITTED RADIUS
This describes the curve radius with the bollard line contouring towards the protected area within the perimeter. The minimum achievable radius is 1550mm, whilst maintaining PAS69 recommended 1.2m spacing between bollards.
EXTERIOR FITTED RADIUS
This describes the curve radius with the bollard line contouring away from the protected area within the perimeter. The minimum achievable radius is 800mm, whilst maintaining PAS69 recommended 1.2m spacing between bollards.
Perpendicular bollard lines should be constructed on the external face of the bollards.
IWA 14-1:2013 Bollard V/7200[N2A]/64/90:3.7 (minimum array of 3)
220 mm (without covers)
1020 mm (without covers)
1200 mm (between bollards)
|Internal Fitted Radius||
|External Fitted Radius||
UK Design number: 6145254